Centroid Community CNC Support Forum

So in restart mode if I was actually cutting a job, would it display the tool path I was cutting and allow me to move the torch head back to a new starting point? What about the Create Pierce Point and Create Resume Point? For the pierce point - will it start there and then move back to the original ...

Thank you - make sure that the documentation gets updated

I was moving the Z axis and this error popped up. The nozzle was nowhere near the plate. What is the intended purpose of the screen that you can move things around on?

Trying to do the Calibrate Arc Voltage test as part of my initial set up with the acorn THC. I just installed 5.30 and I dont see the required macro in the c:\cncm\ncfiles directory

Is there a place to download macros for Acorn Plasma?

So I dont need to set the input to TorchBreakAway? Just use TorchFloat and wire the sensors in series?

Thank you!! It was low and consistent. Would I expect the plot to jump any if I triggered the torch?

I did the THC stray voltage test with my primeweld cut 60 turned on( not firing). I got this plot. There is a little noise compared to not having the plasma turned on. It should be fine correct?

Thanks in advance

I have a round torch mount with 2 NPN NC proximity switches and a Primeweld Cut60 UPM 105 plasma torch with hypertherm consumables. I wired up one of the switches as a breakaway switch and the other as a float switch. I was planning on also adding the torch touch off. I am second guessing the value ...

I confirmed that auto squaring works with the free plasma license!!

I have a Cut 60 with the machine torch that uses hypertherm consumables. Is there a plasma cutter profile set available that would work for the Acorn THC? I was told to use hypertherm 45 cut settings by the folks at Primeweld (there were no instructions with the new torch), the acorn manual says to ...