Centroid Community CNC Support Forum

Motors are not connected to the machine. At this point, I am not sure is I have them configured properly or the correct torque. Any suggestions as to what the settings should be/ how to configure them properly? Thanks Jason

So I removed the cable and connected the db25 directly. Still don't have movement but when I try to jog the axis; the motors hum. They are locked up after the acorn powers on. What do you all think now? Thanks

I have them wired into the DB25. Here are closer photos. Thanks

I disconnected enable 1, 2, and 3 as well as the drive ok wire. Still no motion. Red light is blinking on the drives now. What do you all think I should try next? Thanks

Thanks Everyone, I switched the drives to 5v and my axis configuration already matched the screen shot. I still can't get motion when jogging each axis but I do now get a blip of motion when I turn on or off the control. What's next? Thanks

Thanks for the reply. Yes, the drives are locked when powered up. The slide switches are in the 24v position. Here's the wiring diagram I used. https://www.centroidcnc.com/dealersuppo ... 207.r1.pdf
Thanks again. Jason

Hello Everyone, I am converting a 2001 Koike Aronson Monograph plasma to centroid. I am using Stepperonline motors and drives.
For the X and Y axis, they are both TS Series 1 Axis 12.0Nm(1699.34oz.in) Nema 34 Closed Loop Stepper with CL86T drives. I will be running Gam #700614 10:1 gearboxes.
The Z ...