Centroid Community CNC Support Forum

Acorn newbie here,
So I have a small desktop 4axis cnc setup. It has a 36vdc ps for the spindle, no vfd. Spindle controller.jpg
I have power in, power to motor. There is a toggle switch that reverses polarity/direction of the spindle and flat ribbon cable that goes to a potentiometer that controls ...

Hey thanks this is what I'm looking for if there is no way to change the embedded ip for the Acorn.

On my test bench, where I test another Acorn along with various experimental electronic devices, I have a desktop PC with two network cards. One card has a static IP address that matches the Acorn's ...

I understand that a dedicated pc should be used, the question is can the ip address, subnet mask and gateway of the Acorn be changed?

Hello,
I am trying to find some information out about the Acorn ip address being
hardcoded. I want to buy the unit but it seems I will have to have 2 nic's
in my pc to access the 10.x.x.x network. Can I change the ip address of the
Acorn board to be on my network?
Thanks in advance,
Larry