Centroid Community CNC Support Forum

To cncsnw...
Thanks again. Mill is up and running and the table is moving like a charm.

Keep calm and wire on!

Thank you very much for the help. I will be wiring shortly and will let you know how I make out.

Keep calm and wire on

My apologies for not being as clear as I could be.
We have decided to go with the plcadd1616 to control the up and down motion of the table (knee control) on our M400 knee mill. I have the board wired with a switching power supply at 5 volts, the 24 vdc supply to the plcadd1616 input side and the ...

Thank you for your ideas and info cncsnw. Will take all into consideration.

Keep calm and wire on!

I just had a question regarding the mounting location of the plcadd1616 board. Is there a specific location predetermined for the board or is it up to the tech depending on the setup of the components in the allin1 main panel?

Keep calm and wire on!

We have a knee mill and are looking to control the up and down motion of the table. The original buttons mounted to the side of the spindle have been removed and would like to control the knee motion with the panel buttons.

Stay calm and wire on!

We are looking at expanding the capabilities by integrating the knee control and perhaps some other features later down the road.

Keep calm and wire on!

We have the Allin1CNC on an M400 mill machine and need some advice on programming the controls/buttons on the main control board. I will be installing the 4AD4DA auxiliary board ( which hasn't been ordered yet) and was wondering if the instructions on how to set the buttons come with it or if there ...

Thank you for the advice and help. The spindle is up and running and the boss is happy.

Stay calm and wire on!

Sorry... yes to all of the previous info.