Centroid Community CNC Support Forum

OK I appreciate the information. I will start the wiring for the main panel I plan to install the VFD in the same panel. I will reach out to automation direct for VFD, contactors ,circuit breakers etc.

Dan

I have no spindle connected.

I was able to complete everything up to item 6 Jog the Motors. I opted not to do this as I only had the single phase connected. I did however have one issue when I attempted Disable Stall Detection. Screenshot 2024-11-27 181736.png I was not able to get (stall detection disabled) to pop up. although ...

Step 6 page 45 Hickory Installation Manual. (initial setup for Absolute Encoder) I believe I have set this up correctly but would like your confirmation I am correct. I have a 3 axis mill so I set P316 to 448? The next step is (Configuring Encoder Counts per Revolution) My encoder type is 23bit ...

I am running into the same lack of information in the leadshine manual it only references the 380 v 3 phase. or 220 v single phase my EL7 is clearly labeled 220 3 phase and 220 single phase. I suspect the manual is not up to date. I am also using same schematic S15219

Dan

Thank you I appreciate the advice. I need to order the VFD for the spindle. It is a Mitsubishi SJ-11-AP. Max amperage is 64 and max input voltage is 200. See picture. It would also be 3 phase 240-volt input.


I have no experience with the products and would like to get the best bang for my buck ...

S15219.r3.pdf S15219.r3.pdf S15208.r5 single phase 220 for test bench.pdf
Greetings Team, I purchased this kit a year ago and have now reached the stage of installing the hickory control. I removed all electrical components except for the limit switches for accessories such as the umbrella tool ...