Centroid Community CNC Support Forum

Update
1) modified mpu11wheeldig.txt to look at mem58 and not mem72 and now dry run works.
2) yes it was the door switch slowing rapid moves.

Still left with 2 problems
1)When setting up probing if you touch the probe off the part it cancels the job . We used to touch the part and back off to ...

Thanks so much . I did see the mem58 reference in the files but don't have the programming knowledge to change it.
In the g28 movement it travels at about 1000mm per minute.
Can I get some expert assistance to check over the files please.

This is the program created by the cnc after inputting dialogue
m94 /17
;Probed position lathe digitizing
;Initial probing angle = 180.00
;Probe along 90.00
;Probing resolution = 5.0000
;Lead-in point X-111.1403 Z-621.1846
;Start Point X-116.8694 Z-621.1846
;End Point X-138.1166
;Lead-out Position ...

hi guys
we lost the hard drive and have rebuilt it with a lot of help from mr Laurent,
we have 2 final problems remaining:
1) when running dry run to check the program the spindle turns on , the dry run led is on (AUX 1).
2) rapid speed is quite slow in relation to what it was
any help greatly ...

Brilliant thanks so much .

Hi everyone,
New here and trying to identify a control set up on a CNC lathe. It's a lathe came with a centroid control the hard drive has failed ( short circuit in memory chip and not recoverable . Trying to start rebuilding the software. But need to at least identify the components before opening ...