Centroid Community CNC Support Forum

I've loaded my file into Acorn and I've used the Probe to find Part Zero per instructions several times today. When I hit Cycle Start the cutter always travels an inch to far in the -Y and is not close to the part. The tool path in the graph looks correct, the depth looks correct, the X looks correc...

Okay, thanks.

So, just load the new job file and Cycle Start?

Is it possible to delete a current job in CNC12?
As I update my model in Fusion360 and run it again I'd rather not have multiple file names for the same job but edit in Fusion and save it as current.

Thanks.

I need to repeat a tool path drilling some holes. Seems my too offset was off and the drill bit did no go down far enough. How can I start from tool 4 in this case?

Gotcha...this helps. Thank you!

I'm using the Probe Cycle function inside of Part Setup. How are the two options you mention different?

Trying to find the part 0,0,0 on the mill. After following instructions in the manual on using the probe to find part Zero X,Y and Z, I noticed there is not option to save or accept the new values. Doe CNC 12 save these new values automatically upon cycle completion?

Suntravel, Thanks so much! I'm out to the shop this morning to setup the tool library, etc. in CNC12 then doing a test run.