Centroid Community CNC Support Forum

A nice benefit of ethercat is that the wiring is pretty much plug and play. As pretty much all sets come with premade cables.

Motor is mounted. Aoon more to follow. Posted an update on the first page

Small update: I "solved" this by swapping out the motor. Due to the motor being 200V and my Delta C2000 being 400V there was just too much de-rating needed. Another option could have been to get a bigger delta drive (7.5-11kw) but that would have cost more than swapping this whole thing. S...

I have acquired a used machine that has a bad Syntec controller. I am weighing my options. The Syntec controller is older and obsolete. The options I am considering is an updated Syntec, Fanuc or to save some money Centroid. The servo Drives are Delta ASDA-M series. This drive is not listed as a su...

I have a friend that runs Innovance SV660N ; on a video, the performance looked quite impressive. From what i remember it was about 200-250usd per axis.
delta b3 is about 360 per axis, other options are above that

This is very nice! Now I just need to come up with a fun project to use this on.

tblough wrote: ↑Sun Sep 08, 2024 3:18 pm

spikee wrote: ↑Sun Sep 08, 2024 11:26 am In VF mode you have a linear curve of voltage/frequency.

Are you sure about that?

It may be a little small, but it should still run an unloaded motor. Why are you trying to run a 200V motor at 32, 22, and 10V? That certainly has to screw things up. And, the motor frequency is base frequency is 60Hz and not 50. First thing i would do is set the output frequency to 60Hz and see if...

I looked at a bit further but seems my vfd is just too light to run this motor with the 380v model limiting the output voltage at 200V for the motor. https://i.imgur.com/ViImnEz.png Best bet i see so far is to just replace the motor. As the other options would be to reinstate the 380V -> 200V transf...

Reset the vfd, did startup wizard, only changed these parameters (bold = default): P00-10 control method velocity mode P00-11 velocity mode vf open ctrl P00-16 load select heavy duty P00-17 carrier freq 4khz P1-00 max out freq 250hz P1-01 motor f base 50hz P1-02 max out volt 1 200v P1-10 mid out fre...