Centroid Community CNC Support Forum

Thank you everyone for your input and help. To anyone following this thread. We wanted to update the thread as we figured out the issue and we have the spindle working correctly now. The issue for our setup was that the Centroid TB316 walks you through inertia tuning and changing parameter 11-0 in t...

1. This is What we are wondering also with the orientation. How do we cancel without the M05 command or is this something we have to custom program into the PLC? I could try and use the tool unclamp command as we have setup a mechanical lock to hold spindle into position during the tool change. Mayb...

1. That makes sense for giving it the command and then now its waiting for another command. Question still remains as I cannot give the control another command after this. Like its still holding and waiting for the orientation to finish. If I try and give it an M03 S command for spindle speed it doe...

1. TSB316 Page 7 notes 10-19 for orientation bottom of that section small note says: "NOTE: check firmware version parameter 00-06. Use Parameter 11-66 instead of 10-19 for version 2.06 and up." We have newer firmware and have 11-66 and 11-52 not 10-19 and 10-20. You can refer to page 9 of...

I have attached the fresh report, this was from yesterday as we have not changed anything. There is actually a wiring diagram for the Delta c2000 drive on your wiring schematics for the Hickory control. I know this isn't exactly the same but we were able to trace the wires that are the same for the ...

Thanks for responding cnckeith! I have that wiring diagram as that is what I used to get everything but the spindle and tool changer working. What I was looking for was a wiring diagram for the Delta C2000 and how it connects to the All in one/add 1616 boards. TB 316 only tells you where the wires g...

I know you all want a fresh report and pictures but that has nothing to do with my questions. I am setting up my spindle and have it running and can see the rpm at the screen. My issue is that I want to use the EMC PG-01L card for a tool changer and I question where some of the wires go. In the TB 3...