Centroid Community CNC Support Forum

Hello Suntravel,

Thanks for your input. I looked at your suggestion and discovered that the total cost will be almost double. I'm not opposed to servos and I'm open to the suggestion however, I have no experience in the servo realm. I've been back and forth with Stepperonline for weeks regarding my ...

Thank you very kindly! I have spoken to several "authorities" at Lincoln and Stepper Online and was getting conflicting info. My question was about voltage drop and timing. I wasn't sure if the controller would compensate or the encoder. However, it appears to be a moot point. Thanks again!

Hello, I'm in the early stages of designing my plasma table. My question is regarding step and direction signals. I purchased the Acorn plasma package. The table dimensions are 6 X 12. I'm actually repurposing an old Torchmate III table. I intend to use Stepper Online Nema 24 kit including:

4 x ...