Centroid Community CNC Support Forum

I definitely will. I have quite a bit of information gathered into this so I just need to put the effort into getting it in a manner that can be shared. The wiring is no where near where I would like it to be at this point. I kind of went deeper into keeping the original CNC4 control box prior to fi...

Sorry for the lack of updates. I have been putting a few hours every other Saturday into the machine between other jobs. Between that and waiting for parts, it has been slow going. I ended up installing an RD-65A power supply only to find that the CNC4 control board was not sending any signals to th...

I know that there is a reason for it to blow. There does not appear to be any blown caps or unidentified leakage anywhere on the board. I'm planning on only plugging in the power to the two power boards and powering it up again. If it blows right away, then there is an internal fault in the power bo...

I hooked everything up and powered on the control box. Nothing moves. Checking some things and I found a blown 3A fuse on the Power-One SPL50-3200 power board that looks to have been blown quite a while ago. I should have the replacement fuse tomorrow to give it a try. Hopefully it is just from some...

Thank you for the replies! And sorry for the lack of a response. I need to dig around in the forum settings and look for the notifications settings. The machine is in VERY good condition! After I offloaded the machine in my shop I was a bit unhappy with myself for spending the money I had given that...

Jason & Darrell, thanks for the discussion so far. I realize that it has been almost a year since the last post in this thread, but I am about to do the same conversion on a Supermax YCM-30 that I just picked up. My motors appear to be the same as Jason's with the same CNC4 controller setup. I d...

I recently purchased a Supermax YCM-30 milling machine from the son of the original owner who passed away. It was converted in the 90's to CNC by Centroid. http://drive.google.com/uc?export=view&id=17sztKIgjnDGcUdXQPa9Mjf7XAdHhi7B1 The control box has the following information on it: PRODUCT CNC...