Hello,
I was writing a tool change macro when I ran into this bizarre behavior. The machine is a moving gantry router with twin motors, in this case axes X and B. Calling G30 positions the machine over the tool height detector correctly, but after it is in position, if it is called a second time ...
Search found 2 matches
- Thu Jan 04, 2024 8:24 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Machine crashes if G30 is called twice
- Replies: 1
- Views: 1718
Machine crashes if G30 is called twice
This post has been liked 0 time(s).
- Mon Dec 04, 2023 8:42 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Entering MDI sets Parameter 64 to 0
- Replies: 1
- Views: 1880
Entering MDI sets Parameter 64 to 0
Hello,
Finally getting my machine moving and encountered some strange behavior. Before homing, if you enter MDI mode, parameter 64 is being reset to 0. This decouples the paired X and B axes, which could be catastrophic if a move is made. Parameter 64 remains set correctly during restarts, but as ...
Finally getting my machine moving and encountered some strange behavior. Before homing, if you enter MDI mode, parameter 64 is being reset to 0. This decouples the paired X and B axes, which could be catastrophic if a move is made. Parameter 64 remains set correctly during restarts, but as ...
This post has been liked 0 time(s).