Does the wire to the touch off clip need to be a shielded cable?
Also does the negative terminal on the THC tx board need to be grounded to the table Earth?
Search found 3 matches
- Mon Oct 07, 2024 6:48 am
- Forum: CNC Plasma
- Topic: A few questions on Duramax 180 torch
- Replies: 9
- Views: 4612
Re: A few questions on Duramax 180 torch
This post has been liked 0 time(s).
- Sun Aug 18, 2024 12:05 am
- Forum: CNC Plasma
- Topic: Hypertherm 45 xp Voltage Divider
- Replies: 7
- Views: 5666
Hypertherm 45 xp Voltage Divider
I have a Hypertherm 45 XP it has a voltage divider. Factory defaults are 50:1 but it also says it has a maximum output of 16v. How do I change this to 10v maximum for the THC?
This post has been liked 0 time(s).
- Sat Aug 10, 2024 7:29 pm
- Forum: CNC Plasma
- Topic: Acorn Plasma THC Controller as router
- Replies: 4
- Views: 6407
Re: Acorn Plasma THC Controller as router
Can I change from just a plasma THC Controller to a router/plasma at a later date if I require to use my plasma as a router
This post has been liked 0 time(s).