Centroid Community CNC Support Forum

I hate to say it but I did do a factory reset and reset the parameters and auto tuned. Maybe its the spindle. Although, it runs fine on the pot.

I’m having trouble getting my CNC Depot S30 spindle to respond to speed control from CNC12. M3 will start the spindle but at about 250 hz and will increase when commanded but only to the upper 300 hz range. It does this with a pulsating sound as well. If I switch the frequency source to the pot on t...

Just a quick follow up. I took cnckieth’s advice and got the TT-1. I can say without a doubt that VERY small end mills can be set with the TT-1. I repeatedly set the length of a 0.010 endmill without breaking it! Interestingly, according to the manual the trigger pressure of the TT-4 is 25 oz nomina...

Thanks so much guys!
Yeah a pound and a half might be too much spring.
I'll make sure its returnable.

Can I use the Centroid TT-4 to touch off a 0.023" endmill without breaking it or must I do it manually?
Thanks,
John