Centroid Community CNC Support Forum

I installed the CNC12 beta yesterday, then created a report and installed it again today. why should this be a report before the update to the beta version?

Is it really necessary for the report to contain the tool table? Restoring an outdated tool table cost me a lot.

I checked it, with every speed change the M command is also output.

Error when resetting the report in the beta, possibly just an unnecessary error message. It works so far.

I work with a cam that optimally adapts the spindle speed to the material (automatically). The speed is also adjusted during processing.

It is a Delta VFD055E43A inverter.

CNC12 doesn't wait for the spindle when it changes the speed, at least I can't find any parameters where I could set a pause for waiting when the speed changes like with my old CNC control

https://www.di-soric.com/int-en/PM/Sens ... SL__202765

+ finder Relay because of pnp circuit.

https://youtube.com/shorts/DiX6nkmOJwY? ... i_MlzosOLF


https://youtube.com/shorts/I5a9c3_6ah4? ... Igx4M7s68P

The spindle has 24000 rpm.As I understand it, 2 pulses from the sensor per revolution. A maximum of 48,000 pulses per minute.

Is it possible to use the tool spindle speed signal as a feedback signal for the control?