Centroid Community CNC Support Forum

added pics and video of a 4in cricle cut and scrib and a 10in

tryed 120 extention caord no change but notised the hooks test are consistant if it was noise would this be? am i chasing my tail

same panel acorn is on 20amp 120 breaker and plasma is on 60amp 240
same conduit im going to try an extention cord thought of last night cant hurt right

shealded cables and table grounded no change all drain wires grounded on one end in cabinet

ok ill do that tomarow

ya sheilded wires on order taking torch out of energy chain no change

joey
pownded ground rod grounded table (cable on order)
tryed to cut a circle with bolt patern and tryed to rewind and got previous job
also circle worse than before lol idk
first pic old job
second pic 8in circle with bolt holes

yes x and y are belt driven same pullies on both
defiantly open to closed loop what do you recommend i think im at point of giving up on this old stuff
gessed on curent settings thats y im thinking of buying new motors i have came with table
tryed to dyal in with 2in travle dial indacator and ...

link of photos

also all i know about the steppers is they are nema 34 that are 78mm tall
yes i think mabe missing steps but im not sure thinking mabe just the setup because i dont know what i have
motors are 48v power and yes 5v on the drivers

still having troubles thinking of buying new steppers just so i know what i have any thoughts
and if i were how do i size them
thanks again for the help