Centroid Community CNC Support Forum

Just have to push manually the Z+ button till it is out of trigger state, then you can jog it again. (normal centroid behavior...i think )

oeps, my fault. works now

After installing (acornSix router/fresh install), updating firmware.

Doesn't want to communicate with the board.
(installed v5.30 yesterday without issues)

3 attempts, it does a firmware update. (edit: maybe not, can run 5.30 without doing an board upgrade)

edit: works (didn't allow connection ...

Greedy company = greedy customers

looks nice (y) how about 5 axis RTG ?

@Uwe

Well my mill with AcornSix and Ultimate+ is moving 5 axes together in G0

Then i want to see a report from you

Must missed a parameter.

double check if T3 & H3 is selected on top of screen when zeroing!

Banged my head today, why when doing a "change tool" it didn't call the H offset.

Solved with parameter 3 (add 4) so the H will always the selected tool nr, (if i understand it right)

@Chaz

There is a video on NYC CNC on jerky 5axis moves with Fusion. (5 years ago)

This also applies to cnc12 (centroid doesn't do simultaneous moves in rapid move)

TCP: nhaa prefer dynamic work offset & 5x graphics in cnc12 (for table/table setups)

yes, same here v5.22. (but only when using swissi probe app)

Other hand, had a similar issue with my TT in v5.2, after changing a limit input in the wizard & save...TT was triggering in the plc but not when doing a tool length offset. (caused by my keyboard layout...BE ??? ...finally got my an US ...

Are you talking about the Vectric "drag knife toolpath" gadget? I have no issues with it cutting 1/4" EVA foam or cardboard with the Donek drag knife.

yes the gadget: It randomly set the lead-in inside/outside the curves. Yes you can tweak it, but the next time you select & run. It's again ...