Centroid Community CNC Support Forum

Hi there just wondering if there is a way of exporting a .dig file that has been made using the probe tool and exporting it to a stl file so we could 3D print a test piece??
Thanks

Thank you for that, I’ll have a look into this tomorrow

hi there i have a tamagawa fa coder ts5212n335 encoder that i am wanting to check the wiring on to fit to my centroid acorn setup DB9 connector.
does anyone have the correct colour chart please?
my encoder has
red
black
green
green with black trace
yellow
yellow with black trace
blue
blue with ...

Here is my acorn report if that helps, thank you

I have followed the S14983 generic vfd drawing

hi there, i have got to the point of getting acorn to control the vfd and spindle, ive noticed on a few of the different schematics that some of the output 4,5,6 share coms and some have the forward and reverse into the same output, i have attached a few photos of what i am referring to. also some ...

Sure!

I used the s15006.r1 diagram with only one output für driving the turret.
ACORN_rev4, 4 BIT GRAY CODE TURRET LATHE, SINGLE TURRET OUTPUT, STANDARD CONNECTIONS


But what db9-connector? The turret connects the the inputs on H4, and the relay to the outputs on the relay-board?

Sorry for ...

Have you wired in the turret yet please? If so do you have any diagrams.
Thanks
Chris

Hi there I’m currently fitting Avorn to my Emco and I’m at the point where it’s time to set the turret up for tool changes etc, I’ve got everything wired in but I’m looking for settings and parameters, what document should I be using and any plugins for The acorn cncv12? It’s a 8 tool turret.
Thanks ...