Centroid Community CNC Support Forum

Is there by any chance a parameter that I can set which will constrain the sub program search of the main program to a folder within the same in closing folder?

▼Main Program Folder/
├── Main Program.cnc
└── ▼ Subprograms/
├── O9401.cnc
├── O9402.cnc
├── O9403.cnc
│ ...
└── O9412.cnc

This ...

My router has worked fine for about two years now. In the last week though, it has stopped motion without an alarm three or four times.
It has happened 10 minutes into a program and as much as 2 hours into a run.
Could a clue be found in the report Zip? I cannot make out much.
Thanks for any help.

My past experience is only with Mach4 which does skip if the loop is set to zero.

Sometimes when I run either M98 or G65 I would like to "turn the subProgram off by using a loop count of zero. This does not seem to work though as the sub will always run once unless I comment it out. That's difficult when the sub in question is nested in another file.

Is there a way to list these ...

Well, I finally had time to get back to this and searched the forum and found this link.
https://centroidcncforum.com/viewtopic.php?f=60&t=4111&hilit=HY+vfd+set+up

I made the changes that were recommended here and my spindle began to spin up until it was destroyed.

The level of frustration ...

I found the wiring diagram and I think I’m good with that because I had it working on the bench just fine.
But now that I moved it over to the machine, I somehow messed something up and cannot figure out what.
I thought I had set the wizard up from one of Marty’s videos but if I did, I don’t know ...