Centroid Community CNC Support Forum

I did another sample test part in a test run (no torch or thc) so tomorrow I will work on getting the thc setup and then add the hypertherm 45 to the mix. Again I do greatly appreciate everything. I feel like by this weekend I should be able to actually cut something, but I also would like to see if...

Joey, thank you. I was able to dry run the "bear" job and it actually ran without doing the touch off as it should with the edit to the m61 macro and it also honored the feed rates from the profile manager. <scratching my head emoji> One more step forward, again thanks for your time.

So I think this is the game plan / checklist for me to follow: 1. Figure out the settings in the wizard so jobs run at expected feedrates. 2. Finish installing the Acorn THC. 3. Wire up the ohmic to the torch and thc board. 4. Figure out why I cannot set manually the z axis and start a job, the z ax...

Joey, thanks for your time. As for jogging the table it seems to jog just fine and when doing so the feedrate shows to be at 100ipm. The 4ipm is only an issue when running the job. Below is the link to the google photo album, if you need specific pictures let me know and I will add them to the album...

I have a new install and experiencing an issue with the feedrate. When running the centroid sign program and selecting a profile from the profile manager my feed rate defaults to only 4ipm. I am currently running the free version of the cnc software and have not modified any macros that I know of. I...