Search found 5 matches
- Thu May 04, 2023 4:24 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: M400s controller will not power up
- Replies: 7
- Views: 833
Re: M400s controller will not power up
Once again, that worked. You are two for two. I disabled the SATA and the controller booted up I don’t know if the power supply was the original problem, I put the new power supply in and it worked fine, for about a week, then quit. I do know the battery I pulled out of the motherboard was dead. The...
- Wed May 03, 2023 2:39 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: M400s controller will not power up
- Replies: 7
- Views: 833
Re: M400s controller will not power up
I have attached a .jpg of the controller screen page where the boot up stops. I can power on, start boot up. The boot up scrolls through about two pages of syntax, then stops with the following message at the bottom of the page. Request_module[block-major-3] Root fs is not mounted VFS: Cannot open r...
- Tue May 02, 2023 3:08 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: M400s controller will not power up
- Replies: 7
- Views: 833
Re: M400s controller will not power up
I did the manual reset per instructions. It worked. I touched the pins and the controller console powered up. I went into to the bios power management and set the power up settings as described. I can power up and power down. The next problem to come up is it will not finish the boot up. It stops in...
- Mon May 01, 2023 8:51 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: M400s controller will not power up
- Replies: 7
- Views: 833
Re: M400s controller will not power up
Thanks for the reply, I’m going to try the manual reset described above. The fan I was referring to is the exhaust fan on the
Controller cabinet, powered by the power supply. I thought it should come on even if the it wouldn’t boot up.
Controller cabinet, powered by the power supply. I thought it should come on even if the it wouldn’t boot up.
- Fri Apr 28, 2023 4:20 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: M400s controller will not power up
- Replies: 7
- Views: 833
M400s controller will not power up
I have a Centroid model M400s on a Wells Index knee mill. Recently replaced power supply On the controller computer. The reason for the power supply replacement was; incomplete boot ups, finally get to boot up and goes to blue screen, finally got the mill up and running and decided to leave it on ov...