Centroid Community CNC Support Forum

I have a NAS that I use to share my files withh all the computers on that network

I just check mine again and it is gold then when it is cutting it goes gray but when the spindle move to the next part it goes back to gold

I see that but after it is done it reverts back to the same as the rest. I liked how the Shopbot would show the completed cuts. I do like how you can see the file before you start though

I have trail on and do get the trail. What i was wondering if there was a way that the part could change color after it is done cutting. The reason I ask is I had a job that had over 300 small cutouts and wanted to see the parts that are already cut on cnc12. The router moves about randomly cutting ...

I have my homing working but it sets the zero just off the limit switch. I was hoping I could put an offset in as my table corner is +.62X and +1.35 Y. I know I can jog it over to those and do the f1 f10 to set it but would just like to remove that step

I saw that I did bump it up to a better speed

One other thing I notice is when I home it seems to move a lot slower then it did with 4.82

I got the 65 volt supply in and running. After that was all working I installed cnc 5.06 and after a few problems like it not holding all the settings I got it to work. Couldn't understand why the z wasn't working and had to reset the numbers in the config as that was what wasn't holding had to writ...

I still haven't upgrade but was wondering why there has been so many new versions of CNC5 since June I see they are already up to 5.06

I will try running the last version but I will have to clone my hard dive first.