Centroid Community CNC Support Forum

fusion,

Absolutely bee-U-ti-Ful! I am not joking. Those threads are gorgeous. Anyway, enough oohs and drool over here. Good thread work!

Seth

It seems the laser is not actually liking your arrangement. I see crosshair marks when the laser gantry is traversing instead of the laser pausing until next fire.

Seth

Boostedss,

Here:

There should be some alignment photos in the slew of pictures.

Seth

neat...good luck.

I know the mirror alignment is an issue with a lot of people. I will review my older paperwork on their manual. I will see if I have an electronic copy somewhere. I will report the findings soon, i.e. as the mirror are fickle with adjustments.

Just a heads up here:

1. Center ...

Boostedss...if you want me to make a complete schematic, okay. I will but it will be far off from now. Maybe in mid April or late April is when I can probably find time to configure things correctly for the entire build.

Okay. THIS IS NOT 100% CORRECT as I do not know what is going on without a google photos album and set up of current wiring diagrams from you.

I figured this could get you going. I have not accounted for the inputs (end stops), fans, tanks, tubing pump(s), and/or air assistive technology.

The ...

# Update on Building the Simple Schematic

Not so simple. My software keeps halting at removing and adding in specified parts (basically just lines with signification of what goes where).

I will keep trying. I am going to the mfg. of the source that I use for altering the DWG files from Centroid ...

Boostedss,

Hello again. What have you done so far?

Are you using the original PSU for your laser or are you using a new PSU?

Try mechanical switches and an E-Stop for the H-Series.

I will try to make up a set up for your PSU soon after you reply letting me know what has been done and what type ...

First off, I would have powered the controller to do the bench test.

Secondly, I would have powered your PSU for the laser to make sure you are getting the same, exact voltages that are listed on the PSU.

1. DB25, PWM-GND to PSU for laser and/or 2. DB25, PWM to PSU for laser while the entire GND ...

Hello...

I cut my wiring for IN2 and that is easily seen on your last photo you produced here. I used an E-Stop and then used PWM and GND from the DB25.

Seth