Centroid Community CNC Support Forum

I appreciate your input on this. Sorry for the late response here. I ended up just calling Centroid and talking with sales. We ordered a hickory board and some new drives and servos. Installation is underway.

Thank you for the details!

Hello Again,

I have been scouring the forum, literature that has come with the board we purchased and other user accounts online but have been unable to find any sufficient details for my issue. I want to install a wired MPG on my machine. It will be using the Hickory board and I can't find in the ...

Hello All,


Just acquired an old (1997) but young (fewer than 2k hours) Hardinge Cobra 42 lathe. Quick story is - was used by a school and within the 1st year of use, axis board errors and driver parameter issues caused it to be out of commission. The school didn't have the funds to fix it so ...

Hey Guys/Gals,

I have a mill (Fryer MC-50) that is setup with an Oak board. We run a KP-3 probe that is pretty well dialed in (within .000x"). We have found that running square contours gave us a little deviation in relation to the probe measurements and x dimensions were slightly off compared to y ...

Ok, unfortunately I'm too stupid to do this properly. I made the edits that made sense to me and all it did was caused a PLC that failed to load. I don't know what I am doing and made a couple of attempts that ended in failure. Is there anyone that is able to help me with this?

Andy

Thank you!!! I Copied and pasted anything having to do with SSV / FRV into the appropriate locations.

Going to be putting in some OT tomorrow, so maybe i'll load the PLC as well so I can report back. Thank you!!!!

It's very much appreciated

Andy

Maybe is someone who has SSV active in their PLC willing to share it with me so I can make the changes myself?

- Andy

Just following up to see if you got a chance to look into this? If not, no rush. I'm just thankful for your efforts. If there is some literature somewhere or a reference I can check out, id be happy to try myself.

Thanks again!!

Andy

I really appreciate you putting the time in to help me! I have attached my latest PLC.