Centroid Community CNC Support Forum

Thank you. I will give it a try tomorrow.

What is the best way to program text in intercom? Specifically on a mill.

Is there a way to program multiple passes with a fly cutter? I tried linear but it moves x and z at the same rate.

Need some help on this one. In the attached pic, I wired pin 6 ( servo enable input) to the enable pin on the screw terminal of the Acorn board. But the servo will only run if I supply 24v to pin 11 on the driver. Should pin 11 go to the screw terminal? If so what about pin 6? AAservousermanualv6_3_...

Had some time today while waiting for some electrical parts, so I made a monitor mount for the mill. Turned out pretty good. We'll have to see if it's in my way or not.

I guess I went about this wrong, not starting a new build post before I asked questions. But anyway here it is. Too say this is new to me would be an under statement. The closest to cnc I ever got is my burn table. So far everything seems to be going good. All bench tests have been successful. I was...

Hope this works. Model is 110st-m06030lb. Made by Taizhou Yichuan Electric Co.

Add to edit. This is the "standard" version of the pin out.

When hooking acorn up to these drives, if I'm understanding correctly, pin 3=+pulse, pin 14= --pulse, pin 4= +dir., pin 5= --dir.? I'm not sure if I'm right here. Attached is the pin out that I have of the communication port. AAservousermanualv6_3_221201_120103_31.jpg AAservousermanualv6_3_221201_12...

Thank you very much. Sorry about posting in the wrong forum.