Search found 7 matches
- Thu Jul 06, 2023 11:58 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Allin1DC issue after restarting
- Replies: 6
- Views: 923
Re: Allin1DC issue after restarting
I was afraid of that. Thank you.
This post has been liked 0 time(s).
- Wed Jul 05, 2023 4:45 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Allin1DC issue after restarting
- Replies: 6
- Views: 923
- Wed Jul 05, 2023 3:32 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Allin1DC issue after restarting
- Replies: 6
- Views: 923
Re: Allin1DC issue after restarting
The LEDs at the top of the board are all functioning as they should. The LED that shows the PLC is communicating is not on, but all of the ones above it are on. Also the one that normally shows the "1" or other numbers is not on.
This post has been liked 0 time(s).
- Wed Jul 05, 2023 10:50 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Allin1DC issue after restarting
- Replies: 6
- Views: 923
Re: Allin1DC issue after restarting
(Note from the person that wired the machine and checked everything yesterday.) You might clarify about the power that you have tested all of the logic, power supply outputs and the servo motor power from the rectifier. And also that you can see feedback from your pendant on the VCP. So, you can tel...
This post has been liked 0 time(s).
- Wed Jul 05, 2023 10:47 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Allin1DC issue after restarting
- Replies: 6
- Views: 923
Allin1DC issue after restarting
20230630_163316.jpg Turned my machine off and got this screen when I powered it back on. Board has power everywhere it is supposed to and no fuses are blown, but the PLC light is not lit up like it normally is. Voltage is correct everywhere it was tested. It appears that the E-Stop is activated due...
This post has been liked 0 time(s).
- Fri Jun 16, 2023 6:27 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Machine won't set home after a power outtage
- Replies: 2
- Views: 585
Re: Machine won't set home after a power outtage
It actually completely reset the machine to demo mode. I had to enter in all my unlocks again and it started working.
This post has been liked 0 time(s).
- Fri Jun 16, 2023 11:57 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: Machine won't set home after a power outtage
- Replies: 2
- Views: 585
Machine won't set home after a power outtage
Centroid All in On DC controller on Supermax YCM-40.
My shop lost power last night due to storms. My mill won't set home position. I can move all the servos with the controller, but it will not set home so I can run a program. It just says Machine home not set".. Any ideas?
My shop lost power last night due to storms. My mill won't set home position. I can move all the servos with the controller, but it will not set home so I can run a program. It just says Machine home not set".. Any ideas?
This post has been liked 0 time(s).