Centroid Community CNC Support Forum

Don't know where you are geographically, but I don't know how you could get a project much cheaper than this.
https://www.ebay.com/itm/185883689673

FYI, I have nothing to do with this sale.

Has there been any resolution to this other than a new board for Greg82? I am setting up a new OAK controller with Yaskawa Sigma 1 drives and having the same issue. Whichever axis is plugged into #1 is fine, other axis will not go to commanded position & accumulate error on PID screen with every...

Since there was no resolution to this thread...and someone else is probably going to have this problem I just installed a new OAK on a Bridgeport VMC 3020 and had the exact same issue at the original poster. Using the default Centroid Umbrella ATC program, my spindle would spin right as the M15 Uncl...