Centroid Community CNC Support Forum

If what you are saying is true, you must be mixing tool height offset methods between ProbeApp and CNC12 but unless you provide the detailed information I asked for above I won't be able to pinpoint the problem. You can email me that info directly if that's easier for you. -swissi Sorry for the del...

As CNCMaryland already said, the Tool Check Function has nothing to do with the ProbeApp. The ProbeApp is a tool to assist in setting the WCS Z0 point in a more convenient way. The end result is the same as if you set WCS Z0 directly in CNC12 so if something doesn't work as expected after WCS Z0 ha...

As CNCMaryland already said, the Tool Check Function has nothing to do with the ProbeApp. The ProbeApp is a tool to assist in setting the WCS Z0 point in a more convenient way. The end result is the same as if you set WCS Z0 directly in CNC12 so if something doesn't work as expected after WCS Z0 ha...

Anyone ever figure out how to get the Probe App to work with the Tool Check function of Acorn? I want the probe app to set design height and measure the Tulane and then I start the job but if at any point, I need to do a tool check to make an adjustment or make any kind of a change when I’m done, a...

Anyone ever figure out how to get the Probe App to work with the Tool Check function of Acorn? I want the probe app to set design height and measure the Tulane and then I start the job but if at any point, I need to do a tool check to make an adjustment or make any kind of a change when I’m done, an...

Ok my new motor arrived and has been installed. My max travel speed went from 200 to 350. I haven’t tried messing with any of the steps settings on the drivers are in the software to see if I can increase that but quite frankly 300 is fine for me. I just wanted to be able to go to 300 that’s what it...

cnckeith wrote: ↑Tue May 09, 2023 8:24 pm great glad the hardware is up to speed, looks like the Windows settings need to be scrutinized.

Yeah. I used the guide again to verify all windows settings. Not sure why the paging file acted up.

cnckeith wrote: ↑Tue May 09, 2023 3:20 pm this must be a pretty old PC? where did it come from? what are the specs? very odd to run into that at this day and age

Brand new DELL, well beyond minimum requirements. Shawn from this forum helped me pick it out so I had the right stuff.

cnckeith wrote: ↑Mon May 08, 2023 5:37 pm

Thanks for the link. Before your post, I actually looked up the same info and increased the file size. So good so far.

Extruded aluminum frame? Wonder if it's flexing in the middle of the span with torque applied? You wouldn't be able to tell pushing it by hand, necessarily. Maybe chuck a pencil in the spindle and tape a sheet of paper on the table, set Z to just touch the tip of the pencil, run full speed and see ...