Search found 9 matches
- Wed Jan 11, 2023 11:34 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
Yeah I’m down in Arkansas I will when I get back to Idaho
- Mon Jan 09, 2023 9:01 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
I haven’t had much time to play with it I’m back on the road but tried to cut some stuff other day and torch started to dive into metal again. Haven’t had time to look at it and see where the interference is at but weird cut same piece day before and cut really good then cut another the next day sam...
- Sun Jan 08, 2023 10:07 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
I do have the box grounded to same 8’ grounding rod as table. Is that bad?
- Sat Dec 24, 2022 1:18 am
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
Guess I should probably of started a new thread I’m no good at this forum stuff
- Fri Dec 23, 2022 11:20 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
Yes maybe bob should be the one answering so I don’t get it wrong but I’ll include pictures. The wires coming out of the plugs that connect to my control box where went to ground I unplugged those per bobs request after I talked to him about issue we found and the interference went down a lot, but i...
- Fri Dec 23, 2022 10:03 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
Yes much appreciated just need to figure out why there is still interference coming from the drive motors, I am plugged the grounded, shield wires, and got it greatly reduced not sure if anyone else has any input to get it better
- Fri Dec 23, 2022 8:19 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
joey didnt want to txt you but this look better?
- Fri Dec 23, 2022 5:38 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
file
- Fri Dec 23, 2022 5:31 pm
- Forum: Acorn CNC Plasma
- Topic: 505 error
- Replies: 24
- Views: 3074
Re: 505 error
joey you want to team view my system and check it out? i tried uploading file but the forum system wont except .tap or .job