Search found 10 matches

by jerryk
Wed Nov 23, 2022 6:11 pm
Forum: Acorn CNC Plasma
Topic: Running plasma table without thc
Replies: 7
Views: 200

Re: Running plasma table without thc

Thanks Joey. That worked.
by jerryk
Wed Nov 23, 2022 3:31 pm
Forum: Acorn CNC Plasma
Topic: Running plasma table without thc
Replies: 7
Views: 200

Re: Running plasma table without thc

I am retrofitting a table and wanted to try some cutting before I spend another $1800 on the acorn thc and a z axis. Thanks for the help.
by jerryk
Wed Nov 23, 2022 1:35 pm
Forum: Acorn CNC Plasma
Topic: Running plasma table without thc
Replies: 7
Views: 200

Re: Running plasma table without thc

hello. yes you can run without the THC. requirement is material must be parallel to the torch. THC enabled ON/OFF is in the Profile manager under THC config. see Plasma Install Manual. https://www.centroidcnc.com/centroid_diy/downloads/acorn_documentation/centroid_acorn_plasma_users_manual.pdf I di...
by jerryk
Tue Nov 22, 2022 3:50 pm
Forum: Acorn CNC Plasma
Topic: Running plasma table without thc
Replies: 7
Views: 200

Re: Running plasma table without thc

Thank you
by jerryk
Tue Nov 22, 2022 1:06 pm
Forum: Acorn CNC Plasma
Topic: Running plasma table without thc
Replies: 7
Views: 200

Running plasma table without thc

I'm retrofitting an old plasma table to acorn. I'd like to try out the table b4 buying the acorn thc and pro software. I just have the free software at the moment. When I try a dry run with the test files that acorn supplies it tries to move the z down. I don't have a z axis yet so it just keeps loo...
by jerryk
Mon Nov 21, 2022 4:30 pm
Forum: Centroid Acorn CNC Controller
Topic: Motor noise
Replies: 10
Views: 235

Re: Motor noise

Trying to figure out how to post video. Hopefully the link above works. The stepper motors make the sound after the move is over.
by jerryk
Mon Nov 21, 2022 1:19 pm
Forum: Centroid Acorn CNC Controller
Topic: Motor noise
Replies: 10
Views: 235

Motor noise

My motors make a ringing noise if I give a G01 command after they finish the move. They don't do it with a G00 command. What am I doing wrong?
I have a video of it but it's too large to attach here.
by jerryk
Thu Sep 22, 2022 1:37 pm
Forum: Acorn CNC Plasma
Topic: Acorn plasma software
Replies: 3
Views: 322

Acorn plasma software

Is there a way to tryout the plasma software just on my pc to see if I like it before I buy it. Also what are the benefits of the ultimate vs the pro software? Is my old powermax 1000 supported with the thc? Also what voltage divider would you recommend for my old plasma cutter?
Thanks