Centroid Community CNC Support Forum

Hello again! I think I have figured out most of the wiring except the "LOW GEAR RANGE" connection. The motor has two speed ranges 1500rpm/8000rpm. It's currently wired as an output from the controller in the Milltronics schematic. The Centroid schematic does have a "Low gear range&quo...

Here's what I found out about the "Up-to-speed" terminal from the Yaskawa inverter:
"That is the signal from the drive that tells the control that the spindle is running at the commanded speed."

Any idea where to connect this to Oak?

Hello, Has anyone wired the Yaskawa spindle drives to Oak before? I need help. I'm trying to wire my Yaskawa Sigma 1 Spindle inverter MC5U2011 to Oak but there are a few of the connections that I'm not able to figure out. I want to make sure I'm hooking up the right wires to the right places on Oak ...