Search found 7 matches
- Thu Feb 15, 2024 9:14 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Input to jog axis
- Replies: 3
- Views: 139
Input to jog axis
I'm in the process of retro-ing another Tree Journeyman 425 and came across a question from the guy I'm helping... Is it possible to emulate the old controllers, three bi-direction toggle switches that will jog the XYZ axis forward or back? I know the MPG and touch screen interface have jog buttons....
- Sun Nov 05, 2023 6:02 pm
- Forum: Acorn CNC Plasma
- Topic: THC inactive after a reset
- Replies: 5
- Views: 1501
Re: THC inactive after a reset
Here is the report file.
Looking at the THC settings I do not see anything remarkable. I did verify the 50:1 on the Hypertherm 65 Sync, and the THC settings in the software. The anti drive threshold is set to 7% does that need to be increased possibly?
Looking at the THC settings I do not see anything remarkable. I did verify the 50:1 on the Hypertherm 65 Sync, and the THC settings in the software. The anti drive threshold is set to 7% does that need to be increased possibly?
- Sun Nov 05, 2023 5:22 pm
- Forum: Acorn CNC Plasma
- Topic: THC inactive after a reset
- Replies: 5
- Views: 1501
Re: THC inactive after a reset
I just did another test cut with a feed hold in the middle of a part purposely set unevenly. When I cycle-resumed the job the "THC Auto" light is lit on the virtual jog panel, the torch does a touch off for height then proceeds to cut but the THC doesn't raise or lower the head to contour ...
- Sun Nov 05, 2023 4:56 pm
- Forum: Acorn CNC Plasma
- Topic: THC inactive after a reset
- Replies: 5
- Views: 1501
THC inactive after a reset
I've been working on mostly small part on a pretty flat table for awhile, so I never noticed my THC wasn't working if I did a mid-job feed-hold or had to run back a few steps for whatever reason. I ran a few test cuts on a unlevel scrap piece to confirm. THC will work fine through the whole job as l...
- Mon Nov 07, 2022 2:29 pm
- Forum: Acorn CNC Plasma
- Topic: Post Processor for Autodesk Fusion 360
- Replies: 11
- Views: 2682
Re: Post Processor for Autodesk Fusion 360
Awesome! thank you Swissi!
- Tue Aug 09, 2022 3:29 pm
- Forum: Acorn CNC Plasma
- Topic: Post Processor for Autodesk Fusion 360
- Replies: 11
- Views: 2682
Re: Post Processor for Autodesk Fusion 360
Thanks Shawn. I did look into (briefly) modifying my Fusion 360 PP for the mill to work with the plasma (I have an Acorn running my CNC mill), but as programing isn't my strong suit, the water started to get deep quickly. Hopefully Swissi is successful in getting a PP for Fusion 360 in the near futu...
- Sun Aug 07, 2022 8:51 pm
- Forum: Acorn CNC Plasma
- Topic: Post Processor for Autodesk Fusion 360
- Replies: 11
- Views: 2682
Post Processor for Autodesk Fusion 360
Are any of you aware of a post processor for Fusion 360, or if there are plans for it to be available in the future?