Well it was something very simple as suggested by your last post. Noticed after turning the machine on the Z+ limit was tripped. Reached over and rotated the axis off the switch and all good. Just not thinking in the heat of the afternoon.
Back to making chips...
Thanks for your help.
Search found 3 matches
- Mon Jun 27, 2022 7:40 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: 6.6 homing the machine ALLIN1DC ON MILL
- Replies: 5
- Views: 1260
Re: 6.6 homing the machine ALLIN1DC ON MILL
This post has been liked 0 time(s).
- Mon Jun 27, 2022 3:48 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: 6.6 homing the machine ALLIN1DC ON MILL
- Replies: 5
- Views: 1260
Re: 6.6 homing the machine ALLIN1DC ON MILL
I did not notice an error message, like Zaxis error or the like. The screen blinks as if it did something. I will try again and take a pick of before and after pressing the button.
Thanks.
Thanks.
This post has been liked 0 time(s).
- Sat Jun 25, 2022 1:35 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: 6.6 homing the machine ALLIN1DC ON MILL
- Replies: 5
- Views: 1260
Re: 6.6 homing the machine ALLIN1DC ON MILL
I've powered up my machine and after pressing the cycle start button (multiple times), nothing happens. I loaded cncm.hom as the indicated program in an attempt to get it to work, but no luck. Is there a parameter setting I should be looking at?
"Machine Home Not Set" / "Press Cycle Start to find ...
"Machine Home Not Set" / "Press Cycle Start to find ...
This post has been liked 0 time(s).