Centroid Community CNC Support Forum

I haven't even gotten my unit out of the box but I'm excited about the VCP potential!
One thing I can't find information on - if I have my monitor in "portrait" mode is it possible to set the control matrix at the top or bottom of the screen? I could only get a 22" resistive touchscreen monitor, and ...

Thank you-

I use a servo because it is smaller and better rpm control

C-Axis with clutch because of the lash in the gearbox

Encoder is needed because the gear ratio is not 1:1

Limit switches are NPN on one end, other end soft limit

Gear ratio for axis drive 2:1 with HTD belt

The conversion ...

I'm in the final planning stages of a CNC lathe conversion, and as a last approach I was test-programming some parts in Intercon to see how easy it was to use.

Aside from the fact that I can't see my part in Graph mode and probably need to learn it a bit better, I noticed it has a lot of preset ...

I'm a CNC newb so my apologies if this is pretty basic stuff - but what constitutes an Axis? Is it assumed this is a motor?

Reason I ask is that I will be setting up a CNC lathe with a spindle servo (1), x-axis (2), z-axis (3). I'll hopefully be able to work with the spindle as a c-axis through the ...

I found your videos on youtube, and safe to say I'm blown away! I've been on+off about converting my lathe, but if I could get to this level of functionality would I ever be thrilled! Quite a while ago I realized Centroid would be the best route for me, and this really seals the deal. Being entirely ...