Centroid Community CNC Support Forum

jcsb wrote: ↑Sat Jun 07, 2025 12:45 pm Has anything changed (DMM) here? Are the any other servo manufacturers in the line to work with Hickory?
John

DMM DYN5 compatibility is still in the works.

There are a few other drives nearly ready. We need to write the setup Tech Bulletins before announcing compatibility.

Onsrud 96C10 table.jpg
This picture will show you the twin 4 x 4 tables of my machine. When licked together they make a 4 x 8' table. There are no axes with multiple motors. The fourth axis is for the second table.
Axis X is table 1
Axis U is table 2
Axis Y is the movement of the spindle on the ...

Hello Jason,

Could you please post a fresh report from this machine? See this thread on how to do that: viewtopic.php?t=1043

I have a quick check for you to see if the drive FETs are shorted. It is part of the production test procedure that every ALLIN1DC goes through before shipping.


First, make sure all power to the ALLIN1DC is off and that the DC motor power to H2 is disconnected.

Take that Klein MM600 and set it to ...

These are the signals going to the motors from the drivers? I'd be wary of the motor signals coupling to the other connections in the cables.

Also, make sure to connect the cable shields on one side. I'd do the cabinet side.

The bin locations can be assigned arbitrarily so I do not see any issue with separate tool racks or distance between them.

I'd put the commands to raise and lower them in the M6 macro. Independent control based on tool/bin number would require more advanced macro work.

P155 should be 0 for that type of probe.

I am a little confused by the message persisting when P153 is set to 0 though.
Is that wiring description giving the pin numbers where it connects to the ALLIN1DC or CPC bulkhead connector?

All depends on the type of signal. Are these simple switches? Are they PNP etc? Fundamentally yes to the question but depends on what type of switch it is.

You also mention 2 axis but then name X y and Z ....


It is possible that the OP is more used to Spanish and the "y" means "and" in this ...

Hello and welcome to the forums!

Yes, people have done this before. You can have Mill and Lathe software installed on the same PC without any conflicts.

It is not a recommended configuration because it will get really annoying needing to switch wiring between the Mill and Lathe configurations. I ...

If you graph the wtb12-row4.ngc program in CNC12 (F8 graph job on the main screen), does it give the same 907 errors on the same lines?