BP Boss Spindle Question


LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
Posts: 5
Joined: Thu Jun 09, 2011 8:42 am
Allin1DC CNC Controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
CNC11: Yes
CPU10 or CPU7: Yes
System Serial Number: none

BP Boss Spindle Question

Post by Grindsmygears » Thu Jun 16, 2011 1:07 pm

I have been contemplating upgrading my old Bridgeport Boss mill to your controls. I have the IV controls. There are two types of spindle drives one is the VRAM. I do not have that drive, I have the other one. Do you do both styles of spindle drives. My main question is, does the new motor fit on both styles of head?

Secondly, I see references to power supplies. Do I need new ones or can I use the existing ones?

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests