Acorn Not Powering Up (Multiple Power Supply Usage)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Locked
martyscncgarage
Posts: 954
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: none
Location: Mesa, AZ

Acorn Not Powering Up (Multiple Power Supply Usage)

Post by martyscncgarage » Thu Feb 01, 2018 4:48 pm

(From CNC Keith):
Hey guys if you are using multiple power supplies an experiencing no start, attached is a draft tech bulletin that covers several solutions to the no start. the best solution seems to be to use a multi voltage output power supply instead of separate units.
ACORN_dual_suppy_tech_bulletin_draft.pdf
(2.61 MiB) Downloaded 57 times
"Jack of all trades, master of none!"
Mesa, AZ

Locked

Who is online

Users browsing this forum: Charlie.G, diycncscott, lilb93 and 1 guest