Page 5 of 5
Re: How to connect a TouchProbe and a ToolSetter at the same time
Posted: Mon May 14, 2018 12:00 pm
by cnckeith
Tool Touch off selection has been added to the v4.12 Wizard i/o drop down list. Use the Wizard to set up the Tool Touch Off and probe inputs.
Re: How to connect a TouchProbe and a ToolSetter at the same time
Posted: Mon May 14, 2018 1:19 pm
by diycncscott
Please post a current report from 4.12
If you have it handy, a report from 4.10 might be helpful as well
Re: How to connect a TouchProbe and a ToolSetter at the same time
Posted: Mon May 14, 2018 3:44 pm
by Muzzer
Here are the reports for 4.10 and 4.12.
Both probes work with both versions using the parameter settings therein.
Re: How to connect a TouchProbe and a ToolSetter at the same time
Posted: Tue May 15, 2018 5:53 am
by Fredsan
This weekend I will also update to V4.12 and post the results of setting-up the probe and toolsetter.
Re: How to connect a TouchProbe and a ToolSetter at the same time
Posted: Wed May 16, 2018 8:38 am
by Chaz
Can the logic being discussed here be used for a lathe tool 'height' adjustment?