Centroid Community CNC Support Forum

I hope this helped answer your question.

Thank you Marty, yes it does.

Been about a month since this was last prodded. Things still looking good for first quarter? Or has this needed to move to a summer expectation?

Wolfenstien wrote: ↑Fri Feb 08, 2019 10:46 am Been about a month since this was last prodded. Things still looking good for first quarter? Or has this needed to move to a summer expectation?

Beta testers do not have it. It is hoped for the next release of software. That won't be worked on until 4.14 is complete and released.
I'll reach over and smack Keith if he tries to look into the Centroid Crystal ball again!

cnckeith wrote: ↑Fri Jan 04, 2019 11:04 am shooting for $225 ish...

P1170975.JPG

It looks very good, there are 16 outputs, so it would work for an ATC, occupying 5 outputs you have to choose 32 tools and you have 11 outputs left, the entries I think are enough for tools and error signals,

Any more on this topic?

benscale160 wrote: ↑Mon Sep 07, 2020 11:29 pm Any more on this topic?

Ether1616 had been out for awhile:
https://www.centroidcnc.com/centroid_di ... oller.html