I use the Gecko drive 320 step and dir servo drives. I see connection diagrams for the 201 and 203 stepper drives
but nothing for the 320 or 340. Is it possible to use the 320 drives with the Acorn board ?
Larry
Gecko Drive servos
Moderator: cnckeith
-
- Posts: 428
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Gecko Drive servos
Larry,
Those drives have step + direction so no issue. You will need a dual voltage 24v and 5v power supply. While we don't have schematic for every drive out there (yet....) as long as they accept step + direction it should work.
Those drives have step + direction so no issue. You will need a dual voltage 24v and 5v power supply. While we don't have schematic for every drive out there (yet....) as long as they accept step + direction it should work.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
-
- Posts: 9912
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Gecko Drive servos
Suggest you use the G201 schematic as a guide.
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ