Erroneous Torque Nomenclature?

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

frijoli
Posts: 393
Joined: Tue Sep 12, 2017 10:03 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
System Serial Number: none yet
Location: Outside Winston-Salem, NC

Re: Erroneous Torque Nomenclature?

Post by frijoli » Mon Jan 15, 2018 7:24 am

BigWillieStyle wrote:
Thu Jan 11, 2018 3:48 pm


What things do you need to apply units of force to in very small amounts?
I'm curious.
Small fixed camera lenses, and screws that hold Borosilicate Glass panel mounts.

I use oz-in torque testers for checking plastic injected molded assemblies all the time. One job is 6 to 14 oz-in. What's that in lb-ft?

Clay
Clay
Outside Winston-Salem, NC

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest