Hello !
Im Just doing the last finishing touches on my mazak lathe retrofit with oak board and i ran a small program to test the machine .
All looks great but the run time graphics come up as they should but its not showing the Trail , i tried F9 on and off but no change !!
Any ideas anyone ?
Thanks
Run Time Graphics
Moderator: cnckeith
-
- Posts: 7363
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Run Time Graphics
zero tool diameter?
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
-
- Posts: 15
- Joined: Sat Feb 09, 2019 10:13 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Monroe Michigan USA
Re: Run Time Graphics
Old thread, I know. But for future readers, here is additional info.
I too had this problem of no trail being shown (but it did show recently, before a centroid software update). Keith's comment made me realize that I did not have a tool specified at all in the gcode. It was hastily written test code and no tool was called out. Simply adding "t1" in the code made trail show (which does have a dia in the tool table).
I too had this problem of no trail being shown (but it did show recently, before a centroid software update). Keith's comment made me realize that I did not have a tool specified at all in the gcode. It was hastily written test code and no tool was called out. Simply adding "t1" in the code made trail show (which does have a dia in the tool table).