Oak Axis Connector
Code: Select all
PIN FUNCTION MICROFLEX CONN/PIN MICROFLEX FUNCTION
1 Z X7/3 CHZ+
2 /Z X7/8 CHZ-
3 B X7/2 CHB+
4 /B X7/7 CHB-
5 A X7/1 CHA+
6 /A X7/6 CHA-
7 LOGIC GND X7/5 DGND
8 LOGIC GND
9 A POS REQ
10 /A POS REQ
11 B
12 POS REQ
13 /B POS REQ
14 POS ERR CLR
15 /POS ERR CLR
16 N/C
17 24 GND
18 BRAKE REQ
19 FAULT IN X3/3 STATUS+
20 24 GND X3/2 STATUS-
21 ENABLE X3/6 DRIVE ENABLE-
22 DRIVE RESET X3/4 DIN0-
23 +24VDC X3/5,7 DIN0+, DRIVE ENABLE+ TIED TOGETHER AT X3
24 LOGIC GND X3/12,14 AIO-, AGND TIED TOGETHER AT X3
25 LOGIC GND
26 AN REQ X3/13 AIN+
27 LOGIC GND
28 AN IN
29 N/C
30 CHASSIS SHIELDS CONNECTED AT MICROFLEX END
Finally, I assumed that Analog Request on the Oak was single ended and connected it to the Microflex Analog input accordingly.
Could one of the engineers at Centroid give this a quick glance and see if my assumptions were correct? I've attached the relevant pages from the Microflex manual for reference. I'd appreciate the sanity check before I connect the drives and possible let the magic smoke out of the drives and/or the Oak!
Thanks,
Tom