Huan Yang VFD Parameter Settings

_______________________________________________________














LOGIN below to POST your questions and comments on AjaxCNC products.

Moderator: cnckeith

Post Reply
martyscncgarage
Posts: 493
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: none
Location: Mesa, AZ

Huan Yang VFD Parameter Settings

Post by martyscncgarage » Thu Sep 07, 2017 11:13 am

Centroid has a schematic to wire up the HY VFDs. Attached are the VFD BASE parameter settings to help get you going if you follow that schematic.
As with any VFD, there are MANY parameter settings to fine tune it to your application. You will have to read the manual, which isn't that terrible.

Remember, the Acorn schematic set can be found here: http://www.centroidcnc.com/centroid_diy ... oller.html
Attachments
HuanYuang VFD Setup for 0-10v input.pdf
(14.75 KiB) Downloaded 36 times
"Jack of all trades, master of none!"
Mesa, AZ

martyscncgarage
Posts: 493
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: Yes
CPU10 or CPU7: No
System Serial Number: none
Location: Mesa, AZ

Re: Huan Yang VFD Parameter Settings

Post by martyscncgarage » Sat Sep 23, 2017 7:18 pm

Please let us know if you find any errors and if you have any tips and tricks to fine tuning the HY VFDs
"Jack of all trades, master of none!"
Mesa, AZ

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests