When the Centroid CNC Software Loses its Acorn (resolved)

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
RGSparber
Posts: 66
Joined: Sat May 27, 2017 2:12 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
System Serial Number: none
Location: Phoenix, AZ
Contact:

When the Centroid CNC Software Loses its Acorn (resolved)

Post by RGSparber » Fri Sep 15, 2017 10:00 am

Recently my new Centroid Acorn CNC system started to complain. After receiving help from Centroid plus doing some poking around, I found a double fault. Somehow a virus program had been installed and was active. I also bumped the Ethernet cable and it was not making full contact. All is well again. This was not a hassle, it was an opportunity to write up my debugging steps.

If you are interested, please see

http://rick.sparber.org/CAEF.pdf

Your comments are welcome. All of us are smarter than any one of us.

Thanks,

Rick

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests