Startup error message for system test

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
Sportbikeryder
Posts: 177
Joined: Thu Jan 26, 2017 11:45 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: 10583
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: Yes
Location: North Carolina

Startup error message for system test

Post by Sportbikeryder »

During some problem troubleshooting, the system test file was reset. The mill is fully functional, and all limit switches and travels are good to go, but I am unable to run the full system test due to having a trt32 table installed (no clearance with the b axis tower).

Is there a line that can be added to the output file to mitigate the error message at startup (some sort of "pass" rather than "failed"

Regards,
John
Startup_error_message
Startup_error_message
cnckeith
Posts: 7166
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:

Re: Startup error message for system test

Post by cnckeith »

John,
Hello. yes. please email support@centroidcnc.com a fresh copy of the system report.zip file and they will help you out. thanks, Keith
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
Post Reply