engraving

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
us mach
Posts: 1
Joined: Wed Mar 01, 2017 4:16 am
Allin1DC CNC Controller: Yes
CNC Control System Serial Number: A900482
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

engraving

Post by us mach »

Is the program for engraving extra .I thought it was part of intercon. is there a cost to add it or is there a code needed to activate it.
Centroid_Tech
Posts: 286
Joined: Thu Mar 18, 2010 2:24 pm

Re: engraving

Post by Centroid_Tech »

The MillWrite engraving software is an additional feature which is currently $500. Verify that you have it installed in your system by pressing the F5(CAM) button from the main screen. If you do not see an MW button then it means that MillWrite is not installed onto your control. Please follow the steps below to install MillWrite onto your control.

1- Download the attached file, win-mw.zip.
2- Extract the contents of the win-mw.zip file into the c:\ directory. This part is critical as the majority of people don't do this correctly.
3- If done correctly, Windows should pop up a message stating that the cncm folder already exists. Merge the two folders.

If the Centroid control is not in DEMO mode, the MillWrite engraving software has its own DEMO which allows you to use the letters a, b, and c. If you provide us with your control serial number or your numeric system ID using the attached tech bulletin, we will be more than happy to provide you with a DEMO code so that you test out MillWrite in its entirety. If you like MillWrite and would like to purchase it, an unlock or activation code will be emailed to you so that when the DEMO mode expires, it will remain on.
Attachments
242 Finding Centroid Control Serial Number.pdf
(591.62 KiB) Downloaded 91 times
win-mw.zip
(2.67 MiB) Downloaded 122 times
When requesting support, please ALWAYS post a current report. Find out how to take a report from your Acorn, CNC11 or CNC10 system here: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

If your question is PLC, Macro or program related, please also post a copy of the program or macro as well.

Without the above information we may not be able to help and/or reply until the required information is posted..
Post Reply