Page 1 of 1
New Acorn CNC Lathe Video, a tour of our in house test mule
Posted: Thu Nov 16, 2017 3:36 pm
by cnckeith
I take you on a tour of the Centroid in house Acorn equipped CNC test mule lathe and demonstrate the turning of two parts with Profiling, Single Point Threading, Rigid Tapping, and more...
https://youtu.be/NjYaWOW1O8w
Re: New Acorn CNC Lathe Video, a tour of our in house test mule
Posted: Thu Nov 16, 2017 9:00 pm
by frijoli
Great video. I can't wait to get my lathe running!
I did see some odd drill movement in this video...
Re: New Acorn CNC Lathe Video, a tour of our in house test mule
Posted: Thu Nov 16, 2017 9:03 pm
by cnckeith
Yeah the drill bit was dull and I was pushing it too hard and it was bending.
Re: New Acorn CNC Lathe Video, a tour of our in house test mule
Posted: Thu Nov 16, 2017 9:11 pm
by DICKEYBIRD
frijoli wrote: ↑Thu Nov 16, 2017 9:00 pm
Great video. I can't wait to get my lathe running!
Yup, lathe's rock; gotta luv CNC lathe videos!
You & me do need to get our hands on Keith's lathe & sharpen up the accel. on the the stepper motors & the VFD though. You reckon?
Re: New Acorn CNC Lathe Video, a tour of our in house test mule
Posted: Thu Nov 16, 2017 10:52 pm
by martyscncgarage
DICKEYBIRD wrote: ↑Thu Nov 16, 2017 9:11 pm
frijoli wrote: ↑Thu Nov 16, 2017 9:00 pm
Great video. I can't wait to get my lathe running!
Yup, lathe's rock; gotta luv CNC lathe videos!
You & me do need to get our hands on Keith's lathe & sharpen up the accel. on the the stepper motors & the VFD though. You reckon?
Better finish yours first Milton.
