401 PLC Error Dected [SOLVED]
Posted: Mon Sep 11, 2017 2:26 pm
Sirs,
I have a Centroid CNC7 running version CPU10 on a Bridgeport Boss Series II Mill.
The last job I ran it was fine and powered it down. About a week later I powered it back up to run a job and I am getting a 401 PLC Error Dected.
I have checked my primary transformer voltages and have 24 & 83 VAC. I am getting 110 volts to the DC310 Servo Drive Plc. I am getting 110 VDC to H1.
I have checked the fuses they are good.
I have replaced the E-Stop Contactor, I thought that maybe it was not pulling in. It does not seem to be getting voltage
I'm not sure what to do or check next.
Thank you.
I have a Centroid CNC7 running version CPU10 on a Bridgeport Boss Series II Mill.
The last job I ran it was fine and powered it down. About a week later I powered it back up to run a job and I am getting a 401 PLC Error Dected.
I have checked my primary transformer voltages and have 24 & 83 VAC. I am getting 110 volts to the DC310 Servo Drive Plc. I am getting 110 VDC to H1.
I have checked the fuses they are good.
I have replaced the E-Stop Contactor, I thought that maybe it was not pulling in. It does not seem to be getting voltage
I'm not sure what to do or check next.
Thank you.