Startup error message for system test
Posted: Thu Sep 07, 2017 3:30 pm
During some problem troubleshooting, the system test file was reset. The mill is fully functional, and all limit switches and travels are good to go, but I am unable to run the full system test due to having a trt32 table installed (no clearance with the b axis tower).
Is there a line that can be added to the output file to mitigate the error message at startup (some sort of "pass" rather than "failed"
Regards,
John
Is there a line that can be added to the output file to mitigate the error message at startup (some sort of "pass" rather than "failed"
Regards,
John